There is no automatic switch that returns control to the hub monitoring server when it is available. If you want to switch back to the hub monitoring server, you must manually stop the backup monitoring server. Configuring the Hot Standby feature involves the following steps: 1. Installing the hub and backup hub monitoring servers at the same time. 2. Adding application support on the backup hub monitoring server. 3. Configuring the Hot Standby feature on monitoring server. 4. Configuring agents. 5. Verifying that failover support is working. 5.2.9 Installing hub and backup hub monitoring servers at same time When you are installing the backup hub monitoring server, use identical values to those you used when installing the primary hub monitoring server. If you have previously installed the hub monitoring server and are returning now to install the backup monitoring server, see the following section for information about installing and configuring the backup monitoring server. 5.2.10 Adding application support on backup hub monitoring server